From the CLI you can enter the following commands to set your 881 to autonomous mode. Router>enable Router#config t Router(config t)#service-module wlan-ap0 bootimage autonomous Router(config
Welecome To IOS Cisco
This blog was started as a place where Technical Link could share information with our technicians on lessons they had learned during installation of the Cisco products. We decided to open the blog to other technicians who may want to share their experience or are looking for a solution. The tools and information on the site will be free to everyone.
Welecome to IOS Cisco we look forward to hearing from you about your sucesses and your failours with all of Ciscos networking products and software.